EasyManua.ls Logo

LENCO SCD-860 - Maintenance; Specifications

LENCO SCD-860
12 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
CD
S/R ratio: 55 dB
Sample frequency: 44.1 kHz 8x oversampling
Quantization: 1 bit DA converter
Laser wavelength: 790 nm
Radio
Frequency range: FM: 87.5 - 108MHz
DAB/DAB+: 174 - 240MHz
Antenna: Telescopic
Bluetooth
Version: 5.0
Range: 10m
General
Input voltage: AC 230V- 50Hz
Power consumption: 13 W
Output power: 2W + 2W (RMS)
Speaker size: 2.5"
Speaker impedance: 4 Ohm
Phones output: 3.5mm Jack
Battery specication: 6x 1.5V LR14/C/UM2
Dimensions: 240 x 220 x 117mm (wxdxh)
Weight: 1.1 Kg
Commaxx International reserves the right to change the contents of this document without notice.
SPECIFICATIONS
GB 7
CLEANING THE UNIT
Do not use volatile chemicals on this unit. Clean by lightly
wiping with a soft cloth.
IMPORTANT NOTE
If an abnormal display indication or an operating problem
occurs, disconnect the AC power cord and remove the
batteries. Wait at least 5 seconds, then reconnect the AC
power cord or reinstall the batteries.
WARNING
Should the CD door be opened before the reading of the CD
is completed, a jamming noise may occur. This is resolved
by closing the CD door.
CLEANING A CD
If the CD skips or will not play , the disc may need clean-
ing . Before playing, wipe the disc from the centre out with
a cleaning cloth. After playing, store the disc in its case.
MAINTENANCE
CLEANING THE CD LENS
If the CD lens is dusty, clean it with a brush-blower. Blow
several times on the lens
and remove the dust with
the brush. Finger prints may
be removed with a cotton
swab moistened with alcohol.

Related product manuals