Lennox CLIMATIC 40 - Menu and Settings; Menu Navigation; Parameter Editing

8




b) Set password “ 22 ” by the
“ ” and “ ” buttons.
MENU
A) PROBES DISPLAY MENU
Press the “ ” button to enter probes display menu.
“ b01”, “b02”, “b04”, “b06” ,“b07” ,“b08” ,“b021”, appears on the display (depending
on the unit’s conguration).
Once the probe is selected, after a few seconds, “b01” turns into its temperature/
pressure measure.
Press “ Sel ” button for 5 seconds.
“ ”, appears on the display.
Move inside the menu as explained below.
1 sec.
5 sec.
B) SETPOINT SETTINGS AND OPERATING HOURS DISPLAY MENU
C) PARAMETERS EDITING MENU
a) Press “ Pgr ” and “ Sel”,
at the same time, for 5
seconds.
c) Press “ Sel ”, to accept.
d) Press “ Sel ”, to enter
parameters Editing menu.
Go up a sub-group inside
the programming area.
UP or increase valve.
Down or decrease valve.
Go down a sub-group or accept
parameter modications inside
the programming area.
5 sec.
Access to the menu:
To go to different values in the menu, proceed as above, the: