Page 36 - IOM / ROOF-TOP FLEXY™ Series
USING THE KP02 MAINTENANCE CONTROL DISPLAUSING THE KP02 MAINTENANCE CONTROL DISPLA
USING THE KP02 MAINTENANCE CONTROL DISPLAUSING THE KP02 MAINTENANCE CONTROL DISPLA
USING THE KP02 MAINTENANCE CONTROL DISPLA
YY
YY
Y
Item Minimum value Maximum value
Hours and minutes 00-00H 23-59 H
Day of the month 1 31
Day of the week 1 7
Month 1 12
Year 0 99
For different types of data, the setting ranges are as
follows :
Changes are only incorporated when key [A] is
pressed.
NOTE: The compatibility of the value for the day of
the month is not checked when it is entered. You might
therefore enter February 31st but when you try to
validate, it will be ignored and the preceding value
stored.
3 - POWER SUPPLY (LED 7 - Figure 40)
When lit, the LED indicates that the machine is powered
up.
4 - MODE (LED 8 - Figure 40)
This LED indicates the current operating mode.
In normal mode, i.e. within the programmed schedules,
the LED flashes.
In forced day mode, the LED is permanently on and in
forced night mode, the LED is off.
5 - FILTER DIRTY (LED 3 - Figure 40)
This LED indicates that the Climatic has detected that
the filter is blocked.
6 - GENERAL FAULT (LED 9 - Figure 40)
This LED indicates a general fault has been detected -
refer to page 07 'fault codes'.
To Next Page
Loading...
Need help?
General
