Page 27
II-PLACEMENT AND INSTALLATION
Make sure the unit is installed in accordance with the
installation instructions and all applicable codes. See
accessories section for conditions requiring use of the
optional roof mounting frame.
III-STARTUP - OPERATION
when servicing. See unit nameplate for minimum circuit
ampacity and maximum fuse size.
A-Preliminary and Seasonal Checks
1 - Make sure the unit is installed in accordance with
the installation instructions and applicable codes.
2 -
installed for loose connections. Tighten as required.
control box cover.
3 - Check to ensure that refrigerant lines are in good
condition and do not rub against the cabinet or
other refrigerant lines.
4 -
or TB2. Voltage must be within the range listed on
and have the voltage corrected before starting the
unit.
nameplate for maximum rated load amps.
6 -
B-Heating Startup
FOR YOUR SAFETY READ BEFORE LIGHTING
WARNING
Electric shock hazard. Can cause injury
or death. Do not use this unit if any part
has been under water. Immediately call a
unit and to replace any part of the control
system and any gas control which has
been under water.
BEFORE LIGHTING smell all around the appliance area
Use only your hand to push in or turn the gas control knob.
This unit is equipped with an automatic spark ignition
move thermostat switch to OFF and return the thermostat
switch to HEAT to reset ignition control.
WARNING
or product or property damage. If
overheating occurs or if gas supply
electrical supply.
WARNING
Electric shock hazard. Can cause injury
or death. Before attempting to perform
any service or maintenance, turn the
electrical power to unit OFF at disconnect
switch(es). Unit may have multiple power
supplies.
WARNING
SMOKE POTENTIAL
respect to building occupants and property. Vent
initial supply air outside when possible.
WARNING
death. Do not attempt to light manually.
Unit has a direct spark ignition system.
To Next Page
Loading...
Need help?
General
