L14 Reheat Coil Solenoid Valve
-
3) and refrigerant is routed to the reheat coil.
Reheat Setpoint
Reheat is factory-set to energize when indoor relative hu-
be adjusted by changing Unit Controller Settings - Control
-
gy management system digital output. The reheat setpoint
can also be adjusted using an optional Network Control
Panel (NCP). Reheat will terminate when the indoor rel-
de-energizes. The reheat deadband can be adjusted at
Settings - Control menu.
Check-Out
-
dure.
1 - Make sure reheat is wired as shown in wiring
section.
2 - Make sure unit is in local thermostat mode.
3 - Select Unit Controller Service - Test.
The blower and compressor 1 (reheat) should be
operating. Reheat mode will be appear on the Unit
Controller display.
4 - Deselect Unit Controller Service - Test.
Compressor 1 (reheat) and blower should de-
energize.
Default Reheat Operation
TABLE 14
Reheat Operation - Two Cooling Stages - Default
Demands
Operation
Reheat Only
Reheat ON
Blower Low
Reheat ON
free cooling will operate.
free cooling and compressor 1 will operate.
TABLE 15
Reheat Operation - Three Cooling Stages - Default
Demands
Operation
Reheat Only
Medium
free cooling will operate.
free cooling and compressor 1 will operate.
Q-Needlepoint Bipolar Ionizer
The ionizer was designed for low maintenance. The device
are clean for maximum output. The ionizer is located on
IONIZER
ASSEMBLY
FIGURE 36
To Next Page
Loading...
Need help?
General
