Why won't the pilot light stay lit on my Lennox MPDR-3328CPE Indoor Fireplace?
If the pilot light on your Lennox Indoor Fireplace won't stay lit even after following the lighting instructions, the issue might be a defective pilot generator thermocouple. Try cleaning and adjusting the pilot for the maximum flame impingement on the thermocouple. Also, make sure that the connection between the valve and thermocouple are tight and secure.
How to fix a Lennox MPDR-3328CPE Indoor Fireplace spark ignitor that won't light the pilot?
If the spark ignitor on your Lennox Indoor Fireplace won't light the pilot after you've repeatedly pressed the ignitor button, there might be a defective ignitor spark at the electrode. Check for a spark at the electrode and pilot. If there's no spark and everything is properly connected, you may need to replace the ignitor. Also, the gas supply pressure might be incorrect, so check the inlet gas pressure marked on the rating plate to ensure it's within the specified limits.
What to do if Lennox Indoor Fireplace pilot is burning, but no gas to the burner?
If your Lennox Indoor Fireplace pilot is burning but no gas is going to the burner, and the valve knob and wall switch are both 'ON,' the problem could be with the wall switch or its wiring. Check the wall switch and wires for proper connections. You can jumper the terminals at the wall switch; if the burner comes on, replace the wall switch. If that's okay, try jumpering the wires across the wall switch to the valve; if the burner then comes on, the wires are faulty. Alternatively, the thermopile may not be generating sufficient millivoltage. Check the thermopile terminals with a millivolt meter; it should read a minimum of 325 millivolts with the wall switch 'OFF.' If the reading is below this, replace the thermopile.
Why does my Lennox MPDR-3328CPE have frequent pilot/burner outages?
If you're experiencing frequent pilot/burner outages with your Lennox Indoor Fireplace, it could be due to the pilot flame being either too low or too high, causing the pilot/safety to drop out. Try cleaning and adjusting the pilot flame to ensure maximum flame impingement on the thermocouple.
Lists millivolt model numbers for the direct-vent gas fireplace series.
Lists electronic model numbers for the direct-vent gas fireplace series.
Covers hot surfaces, child supervision, and screen door recommendations.
Outlines steps to take if a gas odor is detected, including immediate actions and calls.
Discusses qualified service, annual inspection, and keeping compartments clean.
Provides instructions on how to open the control compartment access panel.
Refers to detailed lighting instructions for millivolt appliances.
Refers to detailed lighting instructions for electronic appliances.
Explains how to adjust flame height on millivolt appliances using the control knob.
Lists maintenance tasks to be performed annually before the burning season.
Lists maintenance tasks to be performed periodically after the burning season.
General| Category | Indoor Fireplace |
|---|---|
| Venting | Direct Vent |
| Product Type | Direct Vent Fireplace |
| Fuel Type | Propane |
| Ignition Type | Electronic |
| Warranty | Limited Lifetime Warranty |
To Next Page