IOM / Rooftop Smart and Linéa™ Range - Page 5
TRTR
TRTR
TR
ANSPORT - HANDLINGANSPORT - HANDLING
ANSPORT - HANDLINGANSPORT - HANDLING
ANSPORT - HANDLING
HANDLING
LINEA™ units :
The equipment can be moved using the lifting holes in the baseframe of the unit.
Some units can only be supported by four slings at right-angles. Others require different length.
It is essential that all lifting hooks are used and that the slings are all of the same size to avoid damaging the equipment.
IMPORTANT :
ALL PANELS MUST BE
IN PLACE FOR RIGGING
CAUTION :
DO NOT WALK ON THE UNIT
Note : Lifting point should be directly above center of gravity (refer to dimension drawing - page 10 to 12)
Figure 5
LINEA
055 - 065 - 075 - 090
Figure 4
LINEA
020 - 025 - 030 - 035 - 040 - 045
SPREADER BARS ARE NOT SUPPLIED BY LENNOX
To Next Page
Loading...
