IOM / Rooftop Smart and Linéa™ Range - Page 67
USING THE KP02 MAINTENANCE CONTROL DISPLAUSING THE KP02 MAINTENANCE CONTROL DISPLA
USING THE KP02 MAINTENANCE CONTROL DISPLAUSING THE KP02 MAINTENANCE CONTROL DISPLA
USING THE KP02 MAINTENANCE CONTROL DISPLA
YY
YY
Y
CALLOUT:
1 LIQUID CRYSTAL DISPLAY
2 RAISE/LOWER KEYS
3 "FILTER" LED (flashing red)
4 "ADDRESS" KEY
5 "MODE" KEY
6 "VALUE" KEY
7 UNIT RUNNING" LED
8 "MODE" LED
9 "GENERAL ALARM" LED.
1 - DISPLAY FORMATS
Hour
Default display. If the display unit has been inactive for 5 minutes, this screen will automatically be displayed.
<--> 12 hours and 59 minutes
Date
<--> 8 April 1999
Variable or setpoint address
Figure 75
This display unit allows you to read and modify all the values
of the variables or setpoints of the rooftop to which it is
connected.
NOTE: If your ROOFTOP already has a KP17 Comfort
display connected (see previous section) simply disconnect
it and connect this panel to the same location, once
completed re-connect the KP17. It is not necessary to switch
off the power to the CLIMATIC™ whilst the KP02/KP17 is
being changed.
The dialogue with the controller is initiated by the Climatic.
If, after 3 attempts, no communication is established, a
message will be displayed signalling the problem. The unit
will then try to re-connect at regular intervals.
To Next Page
Loading...
