Note: You might have to reconfigure the disk arrays after you install hard disk
drives. See the RAID documentation on the IBM ServeRAID Support CD for
information about RAID controllers.
Removing a CD-RW/DVD drive
To remove the CD-RW/DVD drive, complete the following steps.
1. Read the safety information that begins on page vii and “Installation guidelines”
on page 53.
2. Turn off the server and peripheral devices and disconnect all power cords and
external cables.
Attention: In a dc power environment, only trained service personnel other
than Lenovo service technicians are authorized to connect or disconnect power
to the dc power supply. See the documentation that comes with each dc power
supply.
3. Pull the server out of the rack; then, remove the cover (see “Removing the
cover” on page 56).
4. Press the release tab 1 down to release the drive 2; then, while pressing
the tab, push the drive toward the front of the server.
5. From the front of the server, pull the drive out of the bay.
1 Drive retention clip
2 Alignment pins
Chapter 4. Removing and replacing server components 75
To Next Page
Loading...
