Lenovo SE350 User Manual

1
Configuration Installation Guide
Bookshelf Configuration
This document provides important information for installing and removing the bookshelf configuration.
Install the bookshelf configuration
To install the bookshelf configuration, complete the following steps.
Note: Reserve 500 mm empty space in front of the node so that you can have sufficient space to install and remove the node.
1. If you would like to stack your nodes, complete the following steps.
 Hook the six T-pins into place and slide the node sleeve backward.
 Fasten the thumbscrew.
 Repeat step  and step  to stack your node sleeves.
Note: Bookshelf supports up to three node stacks.
2. Align the right bookshelf with the node sleeve and slightly push the bookshelf leftward to hook the six T-pins into place; then,
fasten the two screws.

Lenovo SE350 Specifications

General

Processor	Intel Xeon D-2100 series
RAID Support	RAID 0, 1, 5, 10
Networking	2x 10GbE SFP+ ports, 2x 1GbE ports
Form Factor	Edge Server
Operating System Support	Microsoft Windows Server, Red Hat Enterprise Linux, SUSE Linux Enterprise Server, VMware vSphere
Storage	Up to 16TB SSD

Summary

Bookshelf Configuration

Install the Bookshelf Configuration

Steps to install the bookshelf configuration, including stacking nodes and securing sleeves.

Remove the Bookshelf Configuration

Steps to remove the bookshelf configuration, covering security bezels, thumbscrews, and node sleeves.

DIN Rail Configuration

Install the DIN Rail Configuration

Steps to install DIN rail clips onto power adapter bracket or node sleeve using screws.

Remove the DIN Rail Configuration

Steps to remove DIN rail clips and node sleeves from the DIN rail configuration.

Wall-mounted Configuration

Install the Wall-mounted Configuration

Steps to install the node sleeve or power adapter bracket onto a wall using screws.

Remove the Wall-mounted Configuration

Steps to remove the node sleeve and power adapter bracket from the wall.