1 Retainer bracket 3 Latch bracket tabs
2 Remote Supervisor Adapter II
SlimLine
1. Read the safety information that begins on page vii and “Installation guidelines”
on page 53.
2. Turn off the server and peripheral devices and disconnect all power cords and
external cables.
Attention: In a dc power environment, only trained service personnel other
than Lenovo service technicians are authorized to connect or disconnect power
to the dc power supply. See the documentation that comes with each dc power
supply.
3. Remove the server cover (see “Removing the cover” on page 56).
4. Remove the PCI riser-card assembly (see “Removing the riser-card assembly”
on page 63).
5. Spread the tabs of the latch bracket apart and lift the end of the Remote
Supervisor Adapter II SlimLine, until the tabs release the adapter; then, slide the
other end of the Remote Supervisor Adapter II SlimLine out of the retainer
bracket.
6. Lift the Remote Supervisor Adapter II SlimLine out of the server.
7. If you are instructed to return the Remote Supervisor Adapter II SlimLine, follow
all packaging instructions, and use any packaging materials for shipping that are
supplied to you.
Installing a Remote Supervisor Adapter II SlimLine
An optional Remote Supervisor Adapter II SlimLine can be installed only in a
dedicated slot on the system board. See “System-board optional-device connectors”
on page 9 for the location of the connector. After the Remote Supervisor Adapter II
SlimLine is installed, the system-management Ethernet port on the rear of the
server is active.
Note: Earlier versions of the Remote Supervisor Adapter II SlimLine might not work
in this server. See http://www.lenovo.com/support/ for the supported Remote
Supervisor Adapter II SlimLine.
To install the Remote Supervisor Adapter II SlimLine, complete the following steps.
68 ThinkServer RD120 server Machine Types 6444, 6445, 6446, and 6447: Hardware Maintenance Manual
To Next Page
Loading...
