Attention: In a dc power environment, only trained service personnel other
than Lenovo service technicians are authorized to connect or disconnect power
to the dc power supply. See the documentation that comes with each dc power
supply.
Removing an optional SATA tape drive
To remove a tape drive from the server, complete the following steps. The following
illustration shows removing a SATA tape drive from a 3.5-inch server model.
1. Read the safety information that begins on page vii and “Installation guidelines”
on page 53.
2. Turn off the server and peripheral devices, and disconnect the power cords and
all external cables.
Attention: In a dc power environment, only trained service personnel other
than Lenovo service technicians are authorized to connect or disconnect power
to the dc power supply. See the documentation that comes with each dc power
supply.
3. Remove the cover from the server.
4. Remove the fan-bracket assembly (see “Removing the fan-bracket assembly”
on page 60).
5. Disconnect the tape drive cables from the connectors on the system board.
6. Open the tape drive tray release latch.
7. Gently pull the drive and cables out of the bay.
Note: On a 3.5-inch model server, gently pull the drive cables through the slot
in the left side of the bay and out the front of the server.
8. If you are not installing another drive in the bay right away, install a filler panel
or panels in the bay.
9. If you are instructed to return the drive, follow all packaging instructions, and
use any packaging materials for shipping that are supplied to you.
Removing an optional SCSI tape drive
To remove a SCSI tape drive from the server, complete the following steps. The
following illustration shows removing a SCSI tape drive from a 3.5-inch server
model.
Chapter 4. Removing and replacing server components 77
To Next Page
Loading...
