2.5-inch drives
1. Read the safety information that begins on page vii and “Installation guidelines”
on page 53.
2. Move the handle on the drive to the open position (perpendicular to the drive).
3. Pull the hot-swap drive assembly from the bay.
4. If you are instructed to return the hot-swap drive, follow all packaging
instructions, and use any packaging materials for shipping that are supplied to
you.
Installing a hard disk drive
Locate the documentation that comes with the hard disk drive and follow those
instructions in addition to the instructions in this section.
For information about the type of hard disk drive that the server supports and other
information that you must consider when installing a hard disk drive, see the User
Guide on the ThinkServer Documentation DVD.
Important: Do not install a SCSI hard disk drive in this server; install only SAS hard
disk drives.
To install a drive in a hot-swap bay, complete the following steps.
Chapter 4. Removing and replacing server components 73
To Next Page
Loading...
