Removing a hot-swap power supply
This procedure applies only to server models that have hot-swap power supplies.
See “Removing a non-hot-swap power supply cage assembly (TD100 - some
models)” on page 132 for information about the removal of a non-hot-swap power
supply.
When you remove or install a hot-swap power supply, observe the following
precautions.
Statement 8:
CAUTION:
Never remove the cover on a power supply or any part that has the following
label attached.
Hazardous voltage, current, and energy levels are present inside any
component that has this label attached. There are no serviceable parts inside
these components. If you suspect a problem with one of these parts, contact
a service technician.
Statement 11:
CAUTION:
The following label indicates sharp edges, corners, or joints nearby.
94 ThinkServer TD100 and TD100x: Hardware Maintenance Manual
To Next Page
Loading...
