Lenovo ThinkServer TS200v - Removing and Reinstalling the Front Bezel

6. Press the cover-release button on the side of the server and slide the cover to
the rear of the server to remove the cover.
Removing and reinstalling the front bezel
Attention
Do not open your server or attempt any repair before reading and
understanding the Chapter 1, “About this manual,” on page 1 and the Safety
Information book. To obtain a copy of the Safety Information book, go to:
http://www.lenovo.com/support
This section provides instructions on how to remove and reinstall the front bezel.
To remove and reinstall the front bezel, do the following:
1. Remove all media from the drives and turn off all attached devices and the
server. Then, disconnect all power cords from electrical outlets and disconnect
all cables that are connected to the server.
2. Remove the server cover. See “Removing the server cover” on page 33.
3. Remove the front bezel by releasing the three plastic tabs on the left side and
pivoting the front bezel outward.
Figure 5. Removing the server cover
34 ThinkServer TS200v Types 0981, 0992, 1008, and 1010: Hardware Maintenance Manual