Note: Your microprocessor socket and socket cover might look slightly different
from the illustration.
4. Carefully press the other side of the socket cover downward until the socket
cover snaps into place.
5. Carefully check the corners of the socket cover to make sure that the cover is
secured in the microprocessor socket.
6. Lower the microprocessor retainer and then lower the lever to secure the
retainer. Make sure the lever is locked into position.
Replacing the primary hard disk drive
Attention
Do not open your server or attempt any repair before reading and
understanding the Chapter 1, “About this manual,” on page 1 and the Safety
Information book. To obtain a copy of the Safety Information book, go to:
http://www.lenovo.com/support
This section provides instructions on how to replace the primary hard disk drive.
Figure 26. Installing the socket cover
Figure 27. Securing the socket cover
Chapter 6. Replacing FRUs 53
To Next Page
Loading...
