11. Connect the signal cable and the power cable to the new hard disk drive.
12. Go to “Completing the parts replacement” on page 61.
Replacing the front fan assembly
Attention
Do not open your server or attempt any repair before reading and
understanding the Chapter 1, “About this manual,” on page 1 and the Safety
Information book. To obtain a copy of the Safety Information book, go to:
http://www.lenovo.com/support
Depending on the model type, your server might have a front fan assembly
installed. This section provides instructions on how to replace the front fan
assembly.
To replace the front fan assembly, do the following:
1. Remove all media from the drives and turn off all attached devices and the
server. Then, disconnect all power cords from electrical outlets and disconnect
all cables that are connected to the server.
2. Remove the server cover. See “Removing the server cover” on page 33.
3. Remove the front bezel. See “Removing and reinstalling the front bezel” on
page 34.
4. Disconnect the front fan assembly cable from the power fan connector on the
system board. See “System-board internal connectors” on page 26.
Note: If your server has a secondary hard disk drive installed, remove the
secondary hard disk drive to get easier access to the power fan connector on
the system board. See “Replacing the secondary hard disk drive” on page 43.
Chapter 6. Replacing FRUs 57
To Next Page
Loading...
