23
To reinstall, reverse the steps above.
2.2.7 REMOVING OR INSTALLING A MEMORY MODULE
Do not proceed before reading and understanding the "Safety Precautions" section of this chapter and "Read Me First".
To install a memory module, do the following:
1. Turn off all attached devices and the server.
2. Disconnect the AC power cord from the electrical outlet.
3. Remove the server cover. (See "Removing and reinstalling the server cover")
4. Remove the cooling shroud. (See "Removing and reinstalling the cooling shroud")
5. Open the retaining clips of the appropriate memory slot.
Open the retaining clips of the memory slot
6. Ensure that notch 1 on the new memory module is aligned with key 2 in the memory slot, then insert the memory module.
7. Press the top of the new memory module straight down until the retaining clips close and the new memory module snaps into position.
Installing a memory module.
To remove, reverse the steps above.
To Next Page
Loading...
