24
2.2.8 REPLACING THE RISER 1, 2
Do not proceed before reading and understanding the "Safety Precautions" section of this chapter and "Read Me First".
To remove the Riser 1, 2, Rear HDD module assembly, do the following:
1. Turn off all attached devices and the server.
2. Disconnect the AC power cord from the electrical outlet.
3. Remove the server cover. (See "Removing and reinstalling the server cover")
4. Disconnect all cables connected to the PCIe cards.and rear HDD module.
5. Grasp the assembly with both hands and carefully lift it straight up and off the chassis.
Removing the FHFL module
Removing the riser x8 from FHFL module
To reinstall, reverse the steps above.
To Next Page
Loading...
