encoding to map Unicode chars onto 1 or more
Bits per second 9600/19200/38400/576
00/115200
Selects serial port transmission speed. The speed
must be matched on the other side. Long or noisy
lines may require lower speeds.
Parity None/Even/Odd/Mark/S
pace
A parity bit can be sent with the data bits to detect
some transmission errors. Even: parity bit is 0 if the
num of 1's in the data bits is even. Odd: parity bit is
0 if num of 1's in the data bits is odd. Mark: parity
bit is always 1. Space: Parity bit is always 0. Mark
and Space Parity do not allow for error detection.
They can be used as an additional data bit.
Stop Bits 1/2 Stop bits indicate the end of a serial data packet. (A
start bit indicates the beginning). The standard
setting is 1 stop bit. Communication with slow
devices may require more than 1 stop bit.
Flow Control None/
Hardware RTS/CTS
Flow control can prevent data loss from buffer
overflow. When sending data, if the receiving
buffers are full, a 'stop' signal can be sent to stop
the data flow. Once the buffers are empty, a 'start'
signal can be sent to re-start the flow. Hardware
flow control uses two wires to send start/stop
signals.
VT-UTF8 Combo Key
Disabled/Enabled
Enable VT-UTF8 Combination Key Support for
Recorder Mode Disabled/Enabled With this mode enabled only text will be sent. This
is to capture Terminal data.
Resolution 100x31 Disabled/Enabled Enables or disables extended terminal resolution
Legacy OS Redirection
80x24/80x25
On Legacy OS, the Number of Rows and Columns
Putty KeyPad VT100/LINUX/XTERMR6/
Select FunctionKey and KeyPad on Putty.
Redirection After BIOS
POST
Always
Enable/BootLoader
The Settings specify if BootLoader is selected then
Legacy console redirection is disabled before
booting to Legacy OS. Default value is Always
Enable which means Legaacy console Redirection is
To Next Page
Loading...
