Lenovo ThinkSystem HR650X - Page 52

©
Copyright
L
enovo
201
7
52
PSU Redundant Mode Non-redundant mode
Active/Active
Active/Passive
PSU Redundant Mode:
active/active or
active/passive.
RTC Wake system from
S4/S5
Disabled/Enabled Enable or disable System wake
on alarm event. When enabled,
System will wake on the
hr::min::sec specified
Wake on LAN from S5
Disabled
/Enabled
Enable/Disable LAN to wake the system
Restore AC Power Loss Power On/Power
Off/Last State/Don't
Change
Select Power on , Power off ,Last State, or Keep
Current State.
Restore AC Power Loss
Current State
Power off
Processor Configuration Table(Sub of
Advanced Menu
)
Processor Configuration
Processor Configuration
CPU1 Speed 2.400GHz
CPU2 Speed
2.400GHz
One blank line
Hyper-Threading [ALL] Disable/Enable Enables Hyper Threading (Software Method to
Enable/Disable Logical Processor threads.
Socket0 Core Disable
Bitmap(Hex)
0
0: Enable all cores. FFFFFFF: Disable all cores
Socket1 Core Disable
Bitmap(Hex)
0
0: Enable all cores. FFFFFFF: Disable all cores
Hardware Prefetcher
Enable
/Disable
= MLC Streamer Prefetcher (MSR 1A4h Bit[0])
Adjacent Cache Prefetch Enable/Disable = MLC Spatial Prefetcher (MSR 1A4h Bit[1])
DCU Streamer Prefetcher Enable/Disable DCU streamer prefetcher is an L1 data cache
prefetcher (MSR 1A4h [2]).
DCU IP Prefetcher Enable/Disable DCU IP prefetcher is an L1 data cache prefetcher
(MSR 1A4h [3]).
Monitor/Mwait
Disable/
Enable
Enable / Disable the Monitor/Mwait
QPI Link L0p Enable Disable/Enable Enable - Set the c_l0p_en, Disable - Reset it, Auto -
Auto decides based on Si Compatibility.
QPI Link L1 Enable Disable/Enable Enable - Set the c_l1_en, Disable - Reset it, Auto -
Auto decides based on Si Compatibility.
Link Frequency Select
9.6GB/s
Allows for selecting the UPI Link
Frequency