Lenovo ThinkSystem SD530 V3 - System LEDs and diagnostics display

System-board switches
The following illustrations show the location of the switches, jumpers, and buttons on the server.
Important:
1. Before you change any switch settings or move any jumpers, turn off the server; then, disconnect all
power cords and external cables. Review the following information:
• https://pubs.lenovo.com/safety_documentation/
• “Installation Guidelines”, “Handling static sensitive devices”, and “Power off the server ” in User
Guide or Hardware Maintenance Guide.
2. Any system-board switch or jumper block that is not shown in the illustrations in this document are
reserved.
Note: If there is a clear protective sticker on the top of the switch blocks, you must remove and discard it to
access the switches.
Figure 9. System-board switches
1 SW5 2 SW13
SW5 switch block
Table 15. SW5 switch block definition
Switch
number
Switch name
Usage description
On Off
1 Force BMC reset
Forces hot reset BMC chip Normal (default)
2 Force BMC CPU reset Forces warm XCC and CPU rest
Normal (default)
3
ME security override Enables ME low security mode Normal (default)
4 Password clear
Forces reset uEFI password Normal (default)
5
Low security Enables XCC low security mode Normal (default)
6
ME recovery Forces ME into recovery mode Normal (default)
7
BMC force update
Forces XCC boot
Normal (default)
8
FPGA power permission
override
Ignores Power Permission and allows
system to power on
Normal (default)
30 ThinkSystem SD530 V3 System Configuration Guide