Table 7. Memory details (continued)
Memory Speed
• Minimal Power
• Balanced
• Max
Performance
Select the desired memory speed. [Maximum
Performance] mode maximizes performance. [Balanced]
mode offers a balance between performance and power.
[Minimal power] mode maximizes power savings. When a
preset mode is selected, the low-level settings are not
changeable and will be grayed out. If user would like to
change the settings, choose [Custom Mode] in
“Operating Mode” located under “System Setting”
submenu.
Max Performance is the default setting.
Memory Power Management
• Automatic
• Disable
[Disable] provides maximum performance but minimum
power savings. [Automatic] is suitable for most
applications. When a preset mode is selected, the low-
level settings are not changeable and will be grayed out. If
user would like to change the settings, please choose
[Custom Mode] in “Operating Mode” located under
“System Setting” submenu.
Disable is the default setting.
Socket Interleave
• NUMA
• Non-NUMA
Sets Socket Interleave to NUMA(Non Unified Memory
Architecture) or Non-NUMA. [NUMA]: Memory is not
interleaved across processors. [Non-NUMA]: Memory is
interleaved across processors.
Note: Changing this setting will require a Power Good
reset to take effect.
Patrol Scrub
• Enable
• Disable
Enable/Disable “Patrol Scrub” which proactively searches
the system memory to repair correctable errors. Enable is
the default setting.
Memory Data Scrambling
• Enable
• Disable
Memory Data Scrambling Disable/Enable. Enable is the
default setting.
ADDDC Sparing
• Disable
• Enable
Enable/Disable ADDDC Sparing. This setting is [Disable]
and grayed out when Page Policy is [Adaptive]. Enabling
ADDDC may cause reduced reliability of memory error
correction in virtual lockstep under rare conditions.
Disable is the default setting.
Page Policy
• Adaptive
• Closed
Adaptive Page Policy can improve performance for
applications with a highly localized memory access
pattern; Closed Page Policy can benefit applications that
access memory more randomly. This setting is [Closed]
and grayed out when ADDDC Sparing is [Enable].
Adaptive is the default setting.
Cold Boot Fast
• Enable
• Disable
Enable/Disable “Cold Boot Fast”. Enable is the default
setting.
Memory Test
• Automatic
• Disable
• Enable
[Enable] Enables memory test during normal boot.
[Disable] - Disables this feature. [Automatic] - Skip
memory test by default unless memory configuration
changed or greater than 90 days since last time test ran.
Automatic is the default setting.
RAM Disk Configuration N/A Press Enter to create/remove RAM disks.
Chapter 3. System configuration and boot management 21
To Next Page
Loading...
