Table 16. User security details (continued)
Set Power-On Password N/A Set the power-On password.
The password can only contain the following characters
(no white-space characters allowed): A-Z, a-z, 0-9, ~`!@#$
%^&*()-+={}[]|:;"'<>,?/.\_
Must contain at least one letter
Must contain at least one number
Must contain at least 2 of the following combinations:
• At least one upper-case letter
• At least one lower-case letter
• At least one special character
No more than 2 consecutive occurrences of the same
character
Must be at least 8 characters if doesn’t select other value
in “Minimum password length” option.
Notes: Click the button, pop-up message box will show
up.
• Please type in your password
• Please type in your new password
• Please confirm your new password
• Power-On Password has been set successfully
• The password failed to meet the “Minimum password
reuse cycle” requirements.
• Please enter enough characters
Press Enter to Continue
• The password can’t be changed because the
“Minimum password change interval” time is not
exceeded.
• The password does not meet the minimum password
complexity requirements.
Please check the help for “Set Power-On Password” or
“Set Administrator Password” settings.
• Passwords are not the same
Press Enter to Continue
• Incorrect Password
Press Enter to Continue
• Passwords operation have unknown problem.
Press Enter to Continue
When IPMI command has no response, then pop out this
message.
54 ThinkSystem Server with Intel Xeon SP (1st, 2nd Gen) UEFI Manual
To Next Page
Loading...
