POST Watchdog Timer Value [5] Enter POST loader Watchdog timer value in minutes from
the specified range (5-20).
Reboot System On NMI
• Enable
• Disable
Enable/Disable reboot of the system during non-
maskable interrupt. Enable is the default setting.
Notes:
• If NMI is triggered by NMI button as diagnostic
interrupt, XCC will only drive NMI without reboot
action.
• If NMI is triggered by XCC WebUI/IPMIcmd as
software NMI, XCC will perform action based on
setting. The default reboot timeout is 60 seconds.
Security
Use this menu to configure system security settings.
Chapter 3. System configuration and boot management 39
To Next Page
Loading...
