Table 12. Processors details (continued)
UPI Power Management
N/A Select the desired power management level for the CPU
UPI interface. L1 saves the most power but has longer
latency compared to L0p or Disabled. When a preset
mode is selected, the low-level settings are not
changeable and will be grayed out. If user would like to
change the settings, please choose [Custom Mode] in
“Operating Mode” located under “System Setting”
submenu.
CPU Frequency Limits N/A The maximum frequency (turbo, AVX, and non turbo) can
be restricted to a frequency that is between the maximum
turbo frequency for the CPU installed and 1.2GHz. This
can be useful for synchronizing CPU tasks. Note that the
max frequency for N+1 cores cannot be higher than N
cores. If an illegal frequency is entered, it will
automatically be limited to a legal value. If the CPU
frequency limits are being controlled through application
software, leave this menu item at the default ([Full turbo
uplift]),please choose [Custom Mode] in "Operating
Mode" and [Enable] in "Turbo Mode" located under
"System Setting" submenu.
Recovery and RAS
Use this menu to configure recovery policies and advanced reliability, availability, and serviceability settings.
Chapter 3. System configuration and boot management 37
To Next Page
Loading...
