Switch between graphic/text modes
The setup utilities are launched in graphic mode by default, the utilities can also be launched in text mode.
You can switch between the two modes by referring to sections below.
Graphic mode to text mode
If you have entered graphic mode and need to switch to text mode, perform the following steps.
1. On the main interface, choose UEFI Setup > System Settings > <F1> Start Control.
2. Select Text Setup for <F1> Start Control.
3. Restart the server and press F1.
4. Wait for about 90 seconds, the setup utilities window is displayed in text mode.
Text mode to graphic mode
If you have entered text mode and need to switch to graphic mode, perform the following steps.
1. On the main interface, choose System Settings > <F1> Start Control.
2. Select Tool Suite or Auto for <F1> Start Control.
3. Restart the server and press F1.
4. Wait for about 90 seconds, the setup utilities window is displayed in graphic mode.
4
ThinkSystem Server with Intel Xeon SP (1st, 2nd Gen) UEFI Manual
To Next Page
Loading...
