Figure 11. Front operator panel LEDs
Table 13. Front operator panel LEDs
1 “Power button with power status LED (green)” on page
33
3 “System ID button with system ID LED (blue)” on page
34
2 “Network activity LED (green)” on page 33 4 “System Error LED (yellow)” on page 34
1 Power button with power status LED (green)
You can press the power button to power on the server when you finish setting up the server. You also can
hold the power button for several seconds to power off the server if you cannot shut down the server from
the operating system. The states of the power LED are as follows:
Status Color
Description
Off None No power supply is properly installed, or the LED itself has failed.
Flashing rapidly (four
times per second)
Green The server is turned off and is not ready to be turned on. The power button is
disabled. This will last approximately 5 to 10 seconds.
Flashing slowly (once
per second)
Green The server is turned off and is ready to be turned on. You can press the power
button to turn on the server.
Lit
Green
The server is turned on.
2 Network activity LED (green)
The network activity LED helps you identify the network connectivity and activity.
Chapter 2. Server components 33
To Next Page
Loading...
