This appliance is intended for household use only.
DANGER! CAUTION!
This symbol alerts you that there is dangerous voltage inside.
To prevent electric shock, do not open the enclosure.
IMPORTANT!
This symbol alerts you to read and observe important warnings
and instructions on the unit or in this manual.
Electrical safety and cord handling
• To prevent contact with high voltage
components inside, do not attempt to open the equipment.
• Before installing this equipment, make sure your outlet voltage
corresponds to the voltage stated on the appliance rating label.
• When connecting the equipment, align the plug properly
and insert it fully to prevent electric shock.
• Only use this equipment with the cord and plug supplied, and do not overload the power
outlet.
• If the power cord is damaged, do not use the equipment. The cord must be replaced by the
manufacturer or similarly qualified personnel to avoid a hazard. Contact the after-sales
support line for advice.
CAUTION:
To reduce the risk of fire or electric shock, do not expose this equipment, the cord or plug to
rain or moisture; do not use it anywhere near water or where water splashes or drips; do not
touch the plug with wet hands. In the event of water or other liquids entering the device,
unplug it immediately and clean and dry it as best as possible. Then have it checked for
damage by a qualified technician, or contact the after-sales support line.
• Do not repair the unit yourself. Only have it serviced by qualified personnel. Contact the
after-sales support line for advice.
• Unplug the unit from the power outlet after use to avoid possible damage during electrical
storms, or when the equipment will be unattended or unused for an extended period.
• Do not let the cord hang over the edge of a table or counter, or touch any hot surface. Do
not allow anything to rest on or roll over the power cord, and run any cords so that no one
steps on or trips over them.
• Do not run the cord near heat-producing appliances such as radiators, stoves or irons.
Excessive heat could melt insulation and expose live wires.
• Always grasp the plug, not the cord, when disconnecting the unit. Pulling the cord can
damage the internal wires and may cause a fire.
• Do not install the unit in an inclined position. It is designed to be operated in a horizontal
position only.
To Next Page
Loading...
