CD encoding
1. Set the function button to CD/USB/SD mode and then insert a memory
device (USB drive, SD or MMC card).
2. Press the record REC button, it will take 3-4 seconds to read the memory
device and then, the USB or SD icon will be flashing on the display.
3. Press the skip up or skip down button to select the desired mode (USB
or SD) for encoding, and then press the record REC button again to
confirm. (You can skip this step if only a USB drive or an SD/MMC card
is inserted.)
4. The system will start the encoding mode after a few seconds. Insert your
CD into the playback slot. During encoding, the USB or SD icon will be
flashing on the display.
5. To finish encoding, press the stop button. The display will show “END”
and return to CD/USB/SD mode.
4. During the playback, press the Play/Pause button to pause. Press it
again to resume playback.
5. To skip to the next or previous track, press the Forward Skip or Backward
Skip button.
6. To skip to a specific time within a track, press and hold the Forward Skip
or Backward Skip button until you reach the desired time. Release the
button and the playback will resume.
7. To repeat a specific track, press Repeat button once while that track is
playing. To repeat all the tracks, press the Repeat button twice. To repeat
random tracks, press the Repeat button three times. To cancel repeat
function, press the Repeat button again.
NOTE:
The recording format is preset at MP3 bit rate 128 kbps. The recording speed
is 1:1. Recording will take as long as playing the CD.
To Next Page
Loading...
