Cassette encoding
1. Set the function button to TAPE mode and then insert a memory device
(USB drive, SD or MMC card).
2. Press the record REC button, it will take 3 - 4 second to read the memory
device, then the USB or SD icon will be flashing on the LCD display.
3. Press the skip up or skip down button to select the desired mode (USB
or SD) for encoding, then press the record REC button again to confirm.
(You can skip this step if only a USB drive or an SD/MMC card is
inserted.)
4. The system will start the encoding mode after a few seconds. Insert your
cassette into the playback slot. During encoding, the USB or SD icon will
be flashing on the display.
5. To finish encoding, press the stop button. The display will show “END”
and return to TAPE mode.
NOTE:
The recording format is preset at MP3 bit rate 128 kbps. The recording speed
is 1:1. Recording will take as long as playing the cassette.
1. Press the CD/USB/SD Button once to set the unit to CD mode.
2. Press the Open/Close button to open the CD tray and put the CD in the
tray with the labeled side facing up.
3. Press the Open/Close button again to close the tray. The LCD display
will show “READING” for a few seconds, then the first track on the CD
will automatically start playing. If it is a blank CD or an unrecognizable
CD, it will show “ERROR”.
IMPORTANT!
Ensure that you insert the cassette in the correct direction.
To prevent damage to the cassette, it is highly recommended to remove it
from the equipment after playing.
CD operation
To Next Page
Loading...
