Phono encoding
Cassette operation
1. Set the function button to PHONO mode and then insert a memory
device (USB drive, SD or MMC card).
2. Put your record onto the turntable and get it ready for playback.
3. Press the record REC button. It will take about 3 - 4 seconds to read the
memory device, then the USB or SD icon will be flashing on the LCD
display.
4. Press the skip up or skip down button to select the desired mode (USB
or SD) for encoding, then press the record REC button again to confirm.
(You can skip this step if only a USB drive or an SD/MMC card is
inserted.)
5. The system will start the encoding mode after a few seconds.
6. Lower the tonearm to start playback of the record. During encoding, the
USB or SD icon will be flashing on the display.
7. To finish encoding, press the stop button. The display will show “END”
and return to PHONO mode.
NOTE:
The recording speed is 1:1. Recording will take as long as playing the
record. The recording format is preset at MP3 bit rate 128 kbps.
REC
PAUSE
TURNTABLE CD RADIO USB SD CASSETTE SYSTEM
USB I SD I CASSETTE RECORDALE
FM
AM
PHONO/AUX
CD/USB/SD
BT
TAPE
STANDBY
REC
DEL
PROG
REPEAT
OPEN
CLOSE
FUNCTION SELECT
MULTI AUDIO RECORDER / PLAYER
SD/MMC
USB
AUX- IN
To Next Page
Loading...
