13
2.5.2 EC Declaration of Conformity ´95 for the purpose of the EC
directive relating to Electromagnetic Compatibility
(89/336/EEC)
amended by: 1st amended directive (92/31/EEC)
CE mark directive (93/68/EEC)
Controller of the 8600 series cannot be driven in stand-alone
operation for the purpose of the regulation about electromagnetic
compatibility. (EMC regulation of 9/11/92 and 1st amended directive
of 30/8/95).The EMC can only be checked when integrating the
controller into a drive system.
Lenze GmbH & Co KG, Postfach 10 13 52, D-31763 Hameln
declares that the described "CE-typical drive sytem" with the
controllers of the 8600 series comply with the above described EC
directive.
The compliance with the protected requirements of the EC-EMC
directive was confirmed by an accredited test laboratory.
The conformity evaluation is based on the working paper of the
product standard for drive systems:
IEC 22G-WG4 5/94 EMC product standard including specific test methods for power drive systems
Considered generic standards:
EN 50081-1
/92
Generic standard for noise emission
Part 1: Residential areas, commercial premises and small businesses
EN 50081-2 /93 Generic standard for noise emission
Part 2: Industrial premises
The noise emission in industrial premises is not limited in IEC 22G. This generic
standard is applied in addition to the requirements of IEC 22G.
prEN 50082-2 3/94 Generic standard for noise immunity
Part 2: Industrial premises
The requirements of noise immunity for residential areas were not considered since
these are less strict.
Considered basic standards for the test of noise emission:
Basic standard Test Limit value
EN 55022 7/92 Radio interference
Housing and mains
Frequency range: 0.15...1000 MHz
Class B
for use in residential and commercial
premises
EN 55011 7/92 Radio interference
Housing and mains
Frequency range: 0.15...1000 MHz
The noise emission in industrial premises
is not limited in IEC 22G. This basic
standard is applied in addition to the
requirements of IEC 22G.
Class A
for use in industrial premises
To Next Page
Loading...
