Parameter setting
Parameter setting using the keypad
7
l
EDKVF9333 EN 1.0
2.2.3 Save parameter set
T he parameters must be saved so that the changed settings do not get lost after mains
disconnection.
•
You can establish up to four parameter sets, e.g. if you process different materials on a
machine or if this is required by differ ent operating states (setup mode, ”stand-by”).
•
If you need only one parameter set, save the modifications permanently under parameter set
1, since the controller automatically loads parameter set 1 after mains connection.
How to proceed
1. Change from the menus to the code level using the arrow keys.
”Code” is displayed.
2. Select C0810/1 using
Y
or
B
C0003.
3. Change to the parameter level using PRG.
”Para” is displayed.
4. Select C0810/1 using
Y
or
B
parameter on 1 (also possible at travelling drive).
Note: If the parameter set is to be saved under another number, select 2, 3, or 4 instead of 1.
5. Press SHIF T + PRG .
” OK” is indicated for approx. 1 s.
Now your settings are saved permanently under parameter set 1 (or 2, 3, 4).
CTi Automation - Phone: 800.894.0412 - Fax: 208.368.0415 - Web: www.ctiautomation.net - e.mail: info@ctiautomation.net
To Next Page
Loading...
