Why does Lenze DC Drives motor rotate at Imax and 50 % slip frequency?
The Lenze DC Drives motor might be rotating at Imax and 50% slip frequency because the motor is not connected in-phase. To resolve this, connect the motor in-phase at the terminals U, V, W.
Explains the principle and structure of system blocks (SBs) in Lenze PLCs.
Interface for input/output signals from attached fieldbus modules.
Controls the Servo PLC for states like TRIP, QSP, or controller inhibit.
Contains control functions for drive machine: phase, speed, motor control.
Covers monitoring functions for drive protection against impermissible conditions.
Details the PLC's input/output capabilities, memory, and processing.
Provides an overview of system error sources, meanings, and possible responses.
Lists causes and remedies for various system error messages.
Reference table for codes used in parameter settings and configuration.
To Next Page
General