Lenze c250-S - Electrical Installation

Electrical installaon
If the modules are mounted mechanically, the electrical installaon can be carried out.
If the wiring with the plugs has already been prepared, only the plugs must be plugged into the modules.
Wiring can also be carried out at plugged plugs.
Complete wiring with the respecve plugs.
Plugs at the safety bus coupler:
•
24 V DC
•
Network In
•
Network Out (if used)
Safety Controller (PLC):
•
No wiring required! Supply voltage via the E-bus.
The plug connector at the safety I/O module:
•
24 V DC
•
Safe inputs
•
Safe outputs
An extension with I/O modules is possible.
If several idencal modules are installed in one environment, please pay aenon to the correct
assignment.
"
. . . . . .
E-Bus
E-Bus
C25BAYSQ
"
. . . . . .
E-Bus
E-Bus
DC SELV PELV 24 V /
(+19.2 … +28.8 V)
L-
L+
15
14
13
12
11
10
9
8
7
6
5
4
3
2
1
0
C25BAYAxxx
"
E-Bus
L-
L+
24 V
IN
OUT
EtherCAT
C25BAYCB
DC SELV PELV 24 V /
(+19.2 … +28.8 V)
. . . . . .
SIB
SIA
. . .
,
Electrical installaon
17