Lenze E82ZBC - Page 58

6
Operation
Transmit parameter sets
EDK82ZBC DE/EN/FR 3.1
58

Parameter ändern u speichern----(DUMMYSEITEVOR)---
Copying parameter sets from the keypad to the standard device
Step Key
sequence
Result Action
1. Connect keypad to standard device 2
 xx.xx Hz
The function  is active. The first code is shown in the user menu (C0517/1, Lenze setting: C0050 = Output frequency).
2. Disable controller
 
The drive coasts to a stop.
3.
Select C0002 in the user menu
 
4.

0002 C0002 is selected
5.
 
6.
Select the correct copying function The settings stored in the standard device or in the
function module are overwritten.
z Copying all the available parameter sets (PAR1 ... PAR4 and, if necessary, FPAR1) to the standard device:
– Standard device with function
module Application I/O, AS interface, INTERBUS, PROFIBUS, LECOM-B, DeviceNet, or CANopen

70 PAR1 ... PAR4 and FPAR1 are copied:
Ö ”70” is set
– Standard device with all other
function modules

10 PAR1 ... PAR4 are copied:
Ö ”10” is set
z Copying only the module-specific parameter s et FPAR1 to the function module:
– Only possible for standard
devices with function module INTERBUS, PROFIBUS, LECOM-B, DeviceNet, or CANopen

40 FPAR1 is copied:
Ö ”40” is set