Lenze E82ZBC - Page 59

Operation
Transmit parameter sets
6
EDK82ZBC DE/EN/FR 3.1
59

Parameter ändern u speichern----(DUMMYSEITEVOR)---
ActionResultKey
sequence
Step
z Copying individual parameter sets (PARx and, if necessary, FPAR1) to the standard device:
– Standard device with function
module Application I/O, INTERBUS, PROFIBUS, LECOM-B, DeviceNet, or CANopen

71 PAR1 and FPAR1 are copied:
Ö ”71” is set

72 PAR2 and FPAR1 are copied:
Ö ”72” is set

73 PAR3 and FPAR1 are copied:
Ö ”73” are set

74 PAR4 and FPAR1 are copied:
Ö ”74” is set
– Standard device with all other
function modules

11
PAR1 is copied: Ö ”11” is set

12
PAR2 is copied: Ö ”12” is set

13
PAR3 is copied: Ö ”13” is set

14
PAR4 is copied: Ö ”14” is set
7. Start copying

STOrE or LOAd
The selected parameter sets are copied to the standard device or to the function module. When STOrE or LOAd stops being displayed, copying has been completed.
8. Enable controller

The drive starts running again.