Lenze E94AYCET

8 Process data transfer
8.2 Setting PDO mapping with the »Engineer«
64
Lenze · E94AYCET communication module (EtherCAT®) · Communication Manual · DMS 10.2 EN · 11/2018 · TD06
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
3. Click the Edit PDO button.
The selection window for editing the process data object is opened:
Here you can transfer the individual ports from the Port Selection list to the "PDO_RX0"
receive PDO by clicking the >> button.
The Up and Down buttons serve to shift the sequence of the ports within the PDO.
4. Confirm the selection with OK.
5. Repeat the steps 2. to 4. for the transmit object PDO_TX0.
6. Now link the ports to the application signals in the selected technology application.
Activate the »FB Editor« via the multiplexer codes (> C03000) if this has not been done yet.
If the »FB Editor« is activated, the multiplexer codes (> C03000) are no longer available. In
this case, you must carry out the interconnection directly in the »FB Editor«.