Preface and general information
1-6
SHB9300CRV EN 2.0
1.4.4.1 EC Declaration of Conformity ’95
in the sense of Electromagnetic Compatibility (89/336/EEC)
amended by: First Amendment Directive (92/31/EEC)
CE Mark Directive (93/68/EEC)
The 93XX controllers are no independent devices in the sense of the law about electromagnetic
compatibility (EMVG of 9 Nov., 92 and 1st EMVGÄndG of 30 Aug, 95). The controller can only be
evaluated in terms of EMC after it has been implemented into a drive system.
Lenze GmbH & Co KG, Postfach 10 13 52, D-31763 Hameln
declares the conformity of the described ”CE-typical drive system” withthe 93XXcontrollers to the
above mentioned EC Directive.
Theconformity evaluation is based on the working paper of theproduct standard for drivesystems:
IEC 22G-WG4 5/94 EMC product standard including specific test methods for power drive systems
Considered generic standards:
Generic standard
EN 50081-1 /92 Generic standard for the emission of noise
Part 1: Residential area, commercial premises, and small businesses
EN 50081-2 /93
(used in addition to the requirements of
IEC 22G)
Generic standard for the emission of noise
Part 2: Industrial premises
The emission of noise in industrial premises is not limited in IEC 22G.
prEN 50082-2 3/94 Generic standard for noise immunity
Part 2: Industrial premises
The requirements of noise immunity for residential areas were not considered, since these are less
strict.
To Next Page
Loading...