Mechanical installation
Mounting the new component
Checking the cam distance
4
30
Lenze ¯ MA 12.0022 ¯ 2.0
In a last step, make sure that neither the securing screw nor the retaining clip is
bent/damaged. Parts that are bent/damaged must be replaced.
Fill up new oil (g500 mounting instructions). The oil quantity has to be selected
according to the mounting position during operation. We recommend checking the
correct oil level afterwards.
Breather elements that have been removed before have to be remounted in the correct
place.
Carry out test run
Implement electrical connection before installation into the machine and carry out a
test run.
If faults occur during this process and if they cannot be eliminated using the g500
mounting instructions, please contact the Lenze aftersales service
To Next Page
Loading...
