Applicaon as directed
•
The product must only be actuated under the operang condions and power limits specied in this
documentaon.
•
The product meets the protecon requirements of 2014/35/EU: Low-Voltage Direcve.
•
The product is not classed as a machine under 2006/42/EU: Machinery Direcve.
•
No machine is to be commissioned or put into operaon as intended in conjuncon with the product unl
it has been determined that the machine meets the regulaons of EC Direcve 2006/42/EU: Machinery
Direcve; observe EN 60204−1.
•
Commissioning or pung into operaon as intended is only permied in compliance with the EMC
Direcve 2014/30/EU.
•
The product is not a household appliance. Instead, it is a component that is intended exclusively for
further use in the context of commercial or professional use as dened by EN 61000−3−2.
•
The product can be used according to the technical data if the drive systems have to comply with
categories in accordance with EN 61800−3.
•
Do not use the built-in brakes as fail-safe brakes. Disrupve factors that cannot be inuenced may cause
the braking torque to be reduced.
•
The product is only to be operated together with an inverter.
Foreseeable misuse
•
Use in potenally explosive areas
•
Use in agressive environments
•
Use under water
•
Use under radiaon
•
Use in generator mode
Handling
Product
•
Never commission the product in the event of visible damage.
•
Never modify the product technically.
•
Never commission the product before assembly has been completed.
•
Never operate the product without the required covers.
Device protecon
•
Connect/disconnect all pluggable terminals only in deenergised condion.
•
Only change wiring on connecons in deenergised condion.
•
Only remove the product from the installaon in deenergised condion.
If you carry out any unauthorized technical modicaons or alteraons, all your warranty claims will
become void and no product liability will be accepted.
Safety instrucons
Handling
35
To Next Page
Loading...
