Need help?Do you have a question about the Lesco Commercial plus 705699 and is the answer not in the manual?
Mount the deflector tube bracket to the spreader frame's right side.
Attach the tube bracket mount to the spreader frame's right side.
Mount the offset bracket onto the deflector, inserting into the slot.
Slide the deflector subassembly onto the deflector tube mount.
Secure the offset bracket to the bracket mount using hardware.
Attach the lever rod bracket to the bracket mount, ensuring flange faces inward.
Mount the remote bracket onto the upper handle's right side.
Install the operating lever using appropriate hardware.
Follow general steps to check and set spreader discharge holes closed.
Test pattern uniformity by laying out boxes and adjusting the pattern slide.
Determine effective pattern width and adjust rate control arm for target application.
Utilize calibration gauges to fine-tune spreader settings for specific products.
To Next Page
General
