24
TO INPUT THE TEMPERATURE AND ALTITUDE AT WHICH THE STRIKING DISTANCE FOR EACH CLUB
WAS MEASURED:
The procedure for inputting the temperature and altitude at which each striking distance
was measured begins immediately after inputting the specific
club distances. Follow each of the steps under “To Input The
Striking Distance Of The 8, 6 and 4-iron”. Once the striking
distances have been input, press MODE and follow the
steps below:
1) The last saved temperature will be flashing in
the bottom portion of the display. If you wish to
input a temperature other than the one shown, proceed
to step 2. To save the shown temperature, press MODE and skip to step 3 below.
2) Press and release POWER to begin incrementing through the temperature settings.
The default setting is 75 degrees F. Pressing POWER will increment through a range
of 30 degrees to 120 degrees F in 5 degree increments. When the appropriate tem
perature is displayed, press and release MODE to save your selection and move on to
the altitude input.
in
cm
M
Y
ft
L
O
S
C
L
U
B
T
G
R
To Next Page
Loading...
Need help?
General
