29
INPUT THE TEMPERATURE AND ALTITUDE AT WHICH THE CLUB SELECTOR SETUP WAS
MEASURED.
Once the striking distances have been input, press MODE
and follow the steps below:
1) The last saved Temperature will be flashing in the
bottom portion of the display. If you wish to input
a temperature other than the one shown, proceed
to step 2. To save the shown temperature, press
MODE and skip to step 3 below.
2) Press POWER to begin incrementing through the Temperature settings.
The default setting is 75 degrees F (25 degrees C). Pressing POWER will
increment through a range of 30 degrees to 120 degrees F (0 degrees to
50 degress C) in 5 degree increments. When the appropriate temperture
is displayed, press MODE to save your selection and move on to the
Altitude input.
3) The last saved Altitude will be flashing in the bottom portion of the display. If you
wish to input an Altitude other than the one shown, proceed to step 4. To save the
shown altitude and return to ranging
To Next Page
Loading...
