What to do if Leuze electronic Security Sensors show a safety status error?
If your Leuze electronic Security Sensors indicate a safety status error, remove any obstructions or ensure the device is correctly aligned to resolve the issue.
What to do if Leuze electronic Security Sensors are not aligned, SYNC not occupied?
If your Leuze electronic Security Sensors are not aligned and SYNC is not occupied, align the device following the correct alignment process. Alternatively, connect the RESTART input on the transmitter to switch to the normal operating mode.
What to do if Leuze electronic MLC 500 show an EDM error?
If your Leuze electronic Security Sensors display an EDM error, check the wiring and inspect for contactor faults. After doing so, switch the device off and then back on again.
What to do if Leuze electronic MLC 500 show an OSSD error?
If your Leuze electronic Security Sensors are showing an OSSD error, verify that the connection is correct and check for any potential sources of electrical interference. Then, power cycle the device by switching it off and back on.
What to do if Leuze electronic MLC 500 Security Sensors show Interlock, free beams error?
If your Leuze electronic Security Sensors are showing Interlock, free beams error, press the RESTART button for at least 0.5 seconds to restart the device in the normal operating mode.
How to resolve a microprocessor error on Leuze electronic Security Sensors?
To resolve a microprocessor error on Leuze electronic Security Sensors, check the operating conditions and look for any potential causes of electrical interference. Then, turn the device off and back on.
How to resolve an optics error on Leuze electronic MLC 500 Security Sensors?
To resolve an optics error on Leuze electronic Security Sensors, check for any potential causes of electrical interference, then switch the device off and back on again.
What to do if Leuze electronic MLC 500 show a cascade error?
If your Leuze electronic Security Sensors display a cascade error, check the cascade connection or the mounting of the terminator.
What to do if Leuze electronic Security Sensors show a reset error?
If your Leuze electronic Security Sensors are showing a reset error, check the connection of the RESTART SELECTION pin.
What to do if Leuze electronic Security Sensors show a supply error?
If your Leuze electronic Security Sensors are showing a supply error, check that the connection is correct.
Defines proper usage and potential misuse scenarios of the safety sensor.
Specifies the qualifications and training required for personnel handling the device.
Clarifies responsibilities of manufacturer and operator regarding safety.
Explains the start/restart interlock function and its operation.
Describes the EDM function for monitoring external contactors.
Details the application of point of operation guarding for safety.
Provides the formula and parameters for calculating the safety distance.
Explains calculating safety distances for different field orientations.
Provides general steps and a checklist for mounting the sensor.
Explains the procedure for aligning the transmitter and receiver for optimal performance.
Procedures and checklists for initial setup and post-modification testing.
A checklist for integrators before initial commissioning and after modifications.
Outlines periodic testing requirements for qualified personnel.
Guidance on identifying and resolving faults using LED indicators.
General| Brand | Leuze electronic |
|---|---|
| Model | MLC 500 Series |
| Category | Security Sensors |
| Language | English |
To Next Page