What causes invalid change of operating mode due to reversal of the supply voltage polarity during operation in Leuze electronic Security Sensors?
Check the wiring and programming of the device which controls this signal.
Why is the signal weak on my Leuze electronic Security Sensors due to contamination or poor alignment?
A weak signal could be due to contaminated front screens or poor alignment between the transmitter and receiver. Clean the front screens and check the alignment of the transmitter and receiver to resolve this issue.
What to do if Leuze electronic MLC 520 device failed?
If the device has failed, replace it.
How to troubleshoot external fault in Leuze electronic MLC 520?
Check the connection of the cables and the control signals.
What to do for internal fault in Leuze electronic MLC 520 Security Sensors?
If a restart fails, replace the device.
What to do if EDM operating mode changed during operation of Leuze electronic Security Sensors?
Check the correctness of the selected operating mode, correct the operating mode if required, and restart.
What to do if EDM does not open in Leuze electronic MLC 520?
Actuate the start button if available.
What to do if EDM does not close in Leuze electronic Security Sensors?
Actuate the start button if available.
What to do if there is a short circuit against +24 V at OSSD2 in Leuze electronic MLC 520 Security Sensors?
Check the wiring. Exchange the cable, if applicable.
What to do if there is short circuit against +24 V at OSSD1 in Leuze electronic MLC 520?
Check the wiring. Exchange the cable, if applicable.
Defines correct usage and potential misuse of the safety sensor to ensure safe operation.
Outlines the qualifications and responsibilities of personnel involved with the safety sensor.
Details the safety responsibilities of machine manufacturers and operating companies.
Explains the mandatory safety function for preventing unintended restarts after interruptions.
Describes the function for monitoring external contactors for safety.
Describes using the sensor for hand/finger protection at machine operation points.
Guidelines for positioning the transmitter and receiver for correct operation.
Formula and parameters for calculating the required safety distance according to EN ISO 13855.
How to calculate safety distance for different approach directions.
Specific calculation for safety distance in access guarding scenarios.
Formula for safety distance when accessing the protective field from above.
Calculation for parallel approach in danger zone guarding.
Guidelines on maintaining distances to reflective surfaces to prevent false triggers.
Methods to prevent optical crosstalk and interference between multiple sensors.
Details the pin assignments for transmitter and receiver connectors.
Details the pin assignments and connection diagram for the MLC 520 receiver.
Illustrates a typical circuit diagram for connecting the MLC 520.
How to safely unlock the start/restart interlock after interruptions.
Tests required before initial use and after modifications to the system.
A checklist for integrators to verify proper installation and setup.
Periodic testing requirements for qualified personnel to ensure reliability.
Regular function checks to be performed by trained operators.
General guide for diagnosing and resolving device failures using indicators.
Technical data related to safety standards like PL, SIL, and category.
General| Brand | Leuze electronic |
|---|---|
| Model | MLC 520 |
| Category | Security Sensors |
| Language | English |
To Next Page