What to do if Leuze electronic SD4T 14 display error F28?
If your Leuze electronic Security Sensors display error F28, it indicates an internal hardware fault. The suggested solution is to send the device in.
What to do if Leuze electronic SD4T 14 display error F8*?
If your Leuze electronic Security Sensors display error F8*, it indicates a short circuit between ground and OSSD2 or a cross circuit. To resolve this, remove the short circuit, overload, or cross circuit. Then, turn the supply voltage off and on again.
What to do if Leuze electronic SD4T 14 Security Sensors display error F34*?
If the Leuze electronic Security Sensors display error F34*, it means the EDM timeout has been exceeded because the feedback circuit either closes or will not open. To fix this, check the EDM wiring and then turn the supply voltage off and on again.
What to do if Leuze electronic Security Sensors display error F10?
If your Leuze electronic Security Sensors display error F10, it indicates undervoltage on the power supply. Check the power supply and feed to resolve this issue.
What to do if Leuze electronic SD4T 14 Security Sensors display error F29?
If your Leuze electronic Security Sensors display error F29, it indicates an internal hardware fault. The suggested solution is to send the device in.
What to do if Leuze electronic SD4T 14 display error F38?
If your Leuze electronic Security Sensors display error F38, it indicates an internal hardware fault. The suggested solution is to send the device in.
What to do if Leuze electronic SD4T 14 Security Sensors display error F36?
If your Leuze electronic Security Sensors display error F36, it means the test identification signal from the transmitter is longer than 3 seconds. Check the transmitter test input.
What to do if Leuze electronic Security Sensors display error F4?
If your Leuze electronic Security Sensors display error F4, it indicates an internal hardware fault. The suggested solution is to send the device in.
What to do if Leuze electronic Security Sensors display error F37*?
If the Leuze electronic Security Sensors display error F37*, it indicates an EDM configuration error. To solve this, check the EDM wiring and then turn the supply voltage off and on again.
What to do if Leuze electronic SD4T 14 Security Sensors display error F33*?
If your Leuze electronic Security Sensors display error F33*, it means the EDM operating mode changed during operation. To resolve this, switch the supply voltage off and on again.
General| Brand | Leuze electronic |
|---|---|
| Model | SD4T 14 |
| Category | Security Sensors |
| Language | English |
To Next Page
