Leuze electronic SD4T 14 - SOLID-4 Connection Example with Downstream Relay Module, MSI-RM2

Electrical connection
44 SOLID-4 Leuze electronic
DEUTSCH ENGLISH FRANÇAIS ITALIANO ESPAÑOL NEDERLANDS
7.2.3 SOLID-4 connection example
with downstream relay module, MSI-RM2
Warning!
If K4 and K5 are installed in the same switching rack as the MSI-RM2, each relay must be
connect
ed via a separate connecting cable with the MSI-RM2. The connecting cables must
be routed in a strong conduit so that mechanical damage is prevented. Also be sure to
follow the MSI-RM2 connection and operating instructions.
Note!
Additional functions such as Muting or Cycle
Con
trol can be implemented with intelligent
safety interfaces of the MSI series from Leuze electronic. For this, see accessories in
Chapter 12.3.
a = EDM feedback circuit
b = Positive-driven relays, spark suppression
required
c = Release circuit, 2-channel*
d = Release circuit, 1-channel*
e = External testing selected
f = Polarity for transmission channel 1
g = Start/restart button
h = 2 A fine-wire fuse, melting fuse
*) Always use both contacts in the release circuit.
Fig. 7.2-3: SD4R-E Receiver, TC1, with RES, with EDM and MSI-RM2
1
2 3
4
5
1
2
3
4
5
SOLID-4
SD4R-E
SOLID-4
SD4T
+24 V DC
GND
FE
nc
6
7
8
K5
K4
k4 k5
k5
k4
k5
k4
a
Y1
Y2
B3
A2
B1
14
12
11
24
2221
L+
Ph
L-
N
F
h
L+
Ph
L-
N
MSI-RM2
f
e
g
f
f
b
b
c d