How to fix Leuze electronic CML 720i Ex alignment signal too low?
If the alignment signal is too low on your Leuze electronic Security Sensors, it's likely due to poor alignment between the transmitter and receiver or soiled lens covers. Try these steps: * Adjust the alignment. * Test with a shorter distance between the transmitter and receiver. * Clean the lens cover on both the receiver and the transmitter.
Why is the function reserve too low on my Leuze electronic Security Sensors?
A low function reserve on your Leuze electronic Security Sensors is often caused by poor alignment or dirty lens covers. To resolve this: * Adjust the alignment between the transmitter and receiver. * Test the sensors with a shorter distance between them. * Clean the lens covers on both the receiver and transmitter.
What to do if Leuze electronic CML 720i Ex Security Sensors show a teach error?
If your Leuze electronic Security Sensors are displaying a teach error, this could be due to soiling of the lens covers or poor alignment between the transmitter and receiver. The suggested solution is to clean the lens cover on the receiver and the transmitter, and then check the alignment.
Why are the outputs not active on Leuze electronic CML 720i Ex?
If the outputs of your Leuze electronic Security Sensors are not active, or if they change state without a contour change in the measurement field, it may be because configuration data is being read or written. The suggested solution is to end configuration communication.
What to do if Leuze electronic CML 720i Ex Security Sensors supply voltage is not sufficient?
If the supply voltage to your Leuze electronic Security Sensors is insufficient, check the voltage supply.
How to fix corrupt EEPROM data on Leuze electronic CML 720i Ex?
If the EEPROM data is corrupt on your Leuze electronic Security Sensors, reset the device to factory settings.
Basic overview and key technical specifications of the CML 720i Ex.
Details on device connections, LEDs, and OLED display.
Guides on using the control panel, icons, and menu structure.
Describes beam scanning modes and methods for evaluating beam states.
Techniques to manage unwanted beams and noise.
Connecting multiple units and evaluating specific beam areas.
Configuring output behavior and time-related functions.
Instructions for physically mounting and aligning the light curtain units.
Details on using sliding blocks, swivel mounts, and brackets for installation.
Guidelines for EMC-compliant wiring, shielding, and cable lengths.
Information on connectors, pin assignments, and interface options.
Initial setup including aligning units and teaching environmental conditions.
Advanced settings for digital I/Os, switching behavior, and display.
Setting up the device for communication via the IO-Link interface.
Configuring the device for communication via the CANopen interface.
Examples for configuring beam-stream data via IO-Link and CANopen.
Demonstrates mapping beam areas to output pins and interfaces.
Examples for hole detection and managing blanking areas.
Illustrates smoothing settings and cascading arrangements.
Prerequisites and steps for installing Sensor Studio and USB master.
Steps for connecting the USB master, light curtain, and launching software.
Overview of the DTM menus for identification, configuration, process, and diagnosis.
Guidance on interpreting LED status and identifying failure causes.
Meaning and resolution of error codes displayed by the device.
Instructions for cleaning, maintenance, and firmware updates.
Details for technical support, service hotlines, and repair procedures.
Key technical data including operating range, beam spacing, and optical properties.
Details on response times, cycle times, and minimum object sizes.
Mechanical dimensions and illustrations of mounting accessories.
Structure for part designations and ordering codes.
List of accessories for CANopen/IO-Link interfaces and mounting.
Accessories for PC connectivity and items included in the package.
Conformity declaration specific to devices used in potentially explosive environments.
General| Series | CML 720i |
|---|---|
| Protection class | IP 67 |
| Housing material | Aluminum |
| Connection | M12 connector |
| Application | Explosion protection areas |
| Operating voltage | 24 V DC |
To Next Page
